Different Types of Hand Washing Timers with Hands-Free Activation
- By : DC-Digital sales & marketing
- Category : Timers
- Tags: PLC, Remote controlled from Relay, Sensor, Switch
Help prevent Covid-19 with a series of hand washing timers. Contact us for customization options on all of these timers! The activation method, case type, power type, timer value set method, and more can be customized to your home, school, or business needs.
DC-10T-DN-HAND
Battery operated and designed to last over 20,000 20-second handwashing cycles in a high use environment, this timer is sealed in a NEMA 4X rated enclosure to ensure maximum protection from liquid. This case can be mounted on the wall or set on the counter next to the sink and is portable. The timer duration is easily adjustable with DIP Switches inside the case. The timer remains off until activated with a close range motion sensor to increase battery life. Features a 3 second end-of-period beep to help signal when the timer is done.
Factory Standard Features:
Activation Method – Motion Sensor
Case Type – NEMA 4X
Power Type – Rechargeable 12V 5Ah Battery
Timer Value Set Method – 6 position DIP Switch with preset values
DC-10T-DN-HAND-FOOT
This timer functions similarly to the DC-10T-DN-HAND but comes with different hardware features. This timer runs power wires out the back of the case (connections made inside the case) to offer a permanent setup that doesn’t need to be adjusted once mounted. The front of the case is foamed and all knockout holes are covered in silicone on the inside to make the case more water resistant to splashes. The display remains on and displays 0:00 when not running. The timer resets to the DIP switch value and starts the timer when the foot switch is pressed if it was not already running. Features a 3 second end-of-period beep to help signal when the timer is done.
Factory Standard Features:
Activation Method – Foot Switch
Case Type – Powder Coated IP-66 Aluminum
Power Type – PS-12-700,120-240 Vac power U.L listed wall adapter w/6ft. cord
Timer Value Set Method – 6 position DIP Switch with preset values
DC-10T-DN-BCD-FOOT-EOP
Instead of using DIP switches with preset values, this timer uses four BCD switches on the top of the case. Each digit on the display can be set individually from 0 to 9 so that any custom time needed can be displayed. Pressing the foot switch resets the timer to the BCD value and restarts the timer. Features a 3 second end-of-period beep to help signal when the timer is done.
Factory Standard Features:
Activation Method – Foot Switch
Case Type – Powder Coated IP-66 Aluminum
Power Type – PS-12-700,120-240 Vac power wall adapter w/6ft. cord
Timer Value Set Method – BCD Switches
DC-10T-UP-FOOT
Rather than using a preset timer value, the DC-10T-UP-FOOT starts an upwards counting timer from zero when the foot switch is pressed. This allows for the timer to be used for standard 20 second hand washes and longer surgery scrubs without needing to adjust any timer values. The foot switch performs three functions in a cycle: start, stop, and reset to zero. This timer does not have an end-of-period beep.
Factory Standard Features:
Activation Method – Foot Switch
Case Type – Powder Coated IP-66 Aluminum
Power Type – PS-12-700,120-240 Vac power wall adapter w/6ft. cord
Timer Value Set Method – Foot Switch (counts up)
No Comments